Badger Garbage Disposalbadger garbage disposal

Badger Garbage Disposal Manual


How to Install Badger Garbage Disposal

 

Read through the entire Installation, Care & Use manual before installing the disposer. Determine which of the tools,materials, and accessories you will need before you begin. Make sure you have all necessary disposer parts before installing the disposer.

TOOLS AND MATERIALS YOU WILL NEED:

Slotted Screwdriver, Adjustable Pliers, Plumber’s Putty,Electrical Tape

TOOLS, MATERIALS, AND ACCESSORIES YOU MAY NEED:

Phillips Screwdriver, Drain Auger, 3/8″ Electrical Clamp Connector, Wire Nuts (2), Second 1 1/2″ Drain Trap,Hammer, Hacksaw, Water Hose Clamp, Pipe Wrench,Copper Ground Wire, Dishwasher Drain Connection Kit, Air Gap, Electrical On/Off Switch, Drain Tube Extension

Step to be done

1. Shut off the power to the garbage disposal’s receptacle at the circuit box.
2. Use a pipe wrench or channel lock pliers to loosen the large nuts connecting the sink drain pipe to the P-trap and the sink’s strainer flange. Remove the drain pipe and the flange and clean the old plumber’s putty or sealant from the sink fitting.
3. InSinkErator Quick-Lock Flange Assembly

Spread plumber’s putty or silicone sealant over the top drain opening and press the new Quick-Lock sink flange into place. Slip the gasket and mounting rings over the bottom of the flange and tighten the three mounting bolts with a screwdriver to secure the assembly to the sink.

4. Unscrew the access panel screw on the bottom of the disposal to expose the wiring. Use the wire nuts to twist together the white, black, and green wires with the corresponding wires from the power cord. Reinstall the panel. Make the same connections to the power supply with the wires in the junction box.

5. Mate the three mounting tabs on top of the disposer with the slots in the mounting ring. Turn the mounting ring until the tabs lock into place.

6. Slip the gasket supplied with the disposal over the discharge shoot opening and connect the discharge tube to the P-trap using the factory screws. Tighten the large nuts with the channel lock pliers or pipe wrench.

7. Restore the power to the junction box. Fill the sink with water and turn the switch to the disposal on to check for leaks.

You should follow all the steps above to install your badger garbage disposal but normally when you purchase badger garbage disposal from InSinkErator, they will attached the installation guide/user manual inside the box. So make sure you safely keep the manual and use when needed. If you make it hard to understand all instruction above, visit this website on Badger Garbage Disposal User Manual that contain the original user manual and you can print it and keep on your own.

Incoming search terms:

Share